Frankie Muniz Racingrst. Play continues to the left of the first player. 8 Roll the die and move your piece the appropriate spaces. Follow the instructions on t he space. If you land on a landmark and it is unowned, you have the option of buying the landmark. 9 Continue playing. Roll the die, move th e appropriate spaces and follow the instructions on the space. 10 Collect $2 every time you pass Go. 11 Continue taking turns until a player loses all of his money. The first player to lose all of his money loses and ends the game. 12 Count the remaining players' money. The playe mail icon r with the most money wins the game.1 Secure the metal rod in the vise horizontally. Leave at least three inches more than the desired lengt h of your finished tube. If you want a 20-inch tube, you have at least 23 inches of rod extending from the vice and at least six inches of r Frankie Muniz Racing od secured in the vice. The rod will not be holding an abundant amount of weight, nor will it be resisting pressure. You will be delicately . t three inches of extra tube length for removing it from the mold. 4 Coat the fabric with a layer of epoxy before the fabric is placed over itself. Continue applying the epoxy as you continue wrapping the fabric. You will want at least six layers for a strong tube. Keep in mind t hat the last layer of epoxy on the tube will show, so take your time if you would like the finished tube to look well. Let the epoxy dry for 24 hours. 5 Remove the tube and rod from the vice. Clamp your vice grip around the tube where you provided the extra length. Clamp the othe timeline template r grip around the rod. The vice grip around the tube should be secured well, but not enough to squeeze the tube on to the rod. Twist the gri ps against each other, one clockwise, and the other counter-clockwise. The mold should pop out from its secured position. 6 Remove the tube Frankie Muniz Racing from the rod. Because the mold release wax was on the rod, the inside of the tube should be smooth and the outside of the tube should appear . d is the finned metal fixture sitting atop the main case of the engine. Remove the cooling head from the engine to expose the sleeve within. 2 Slide the head shim around the sleeve, which extends from the combustion chamber. Align them with their grooves facing the front of the e ngine; they are designed to fit snugly, so they will only fit in the correct orientation. 3 Snap the head shims down onto the engine case, p ushing them down flat around the sleeve. The engine sleeve contains the piston, which is drive by the force exerted by the combustible fuel free books download within; therefore, it is important that the shims are flush, forming an airtight seal. 4 Install the cooling head back onto the engine case by tightening the four screws. Turn one screw a single turn, then move diagonally to the next, screwing it down a single turn. Tighten the s Frankie Muniz Racing crews incrementally, following an "X" shape to ensure that the cooling head lays flush on the engine case. Following this procedure will gua .
|