Frankie Muniz Racinghyla" from Belarus This Belarusian game begins with one person, the leader, sitting down in the middle of the room. The rest of the players form a semi-circle behind him so they can only see his back. Hand one of the players a small object. The player passes it on to one of the p layers beside him. The players continue to pass the object around until one player taps the leader on the shoulder. The leader has to guess who among the seated players has the object. If he guesses correctly, the player with the object becomes the new leader. If he makes an inco certificate templates rrect guess, he turns around and the circle passes the object around again in the same way. Play until everyone has had a turn being the lea der.1 Repair the water pump with the outboard on or off the boat. If on, the boat must be out of the water and suitably supported on a trail Frankie Muniz Racing er or stands. Make sure there are three to four feet of free space beneath the lowest part of the outboard to allow the drive shaft to clear . ads to these bolts pointing downward, between the propeller and the horizontal blade or fin. Remove the bolts completely; then gently pull o r push down on the gear housing until it separates from the rest of the outboard. The housing will have the drive shaft attached, so continu e bringing the assembly downward until the shaft is clear. 3 Place the gear housing in the upright position -- as when the outboard is runni ng normally -- before the impeller is extracted. If you don't do this the gear case oil will leak out. The impeller housing is usually plast free romance books ic and is held together by four bolts. Loosen these with an appropriate socket wrench and remove them. Gently pull the top of the housing up ward and gently pull off the intake tube. Now flip the housing over and you should see rubber impeller. If the impeller has lost any of its Frankie Muniz Racing vanes, make sure they and any other parts of the impeller are removed from the impeller housing. 4 Scrape off the old gasket material from t . sing. There should be a stainless steel liner that it fits into. Reassemble the water pump housing using the four bolts, and tighten as per the manufacturer's specifications. Reattach the water intake hose by pushing it onto the seal. 5 Line up (from front to back) the cam rod, t he drive shaft and the water tube as follows: the cam rod with the well immediately in front of the water pump; the drive shaft with the cra nkcase; and the water tube with the top of the pump assembly. Push the gear housing onto the drive shaft housing, reattach the four bolts, a css template nd tighten according to the manufacturer's specifications.Corrosion Corrosion is the primary problem among outboard motor starters. Water an d high humidity reach starter parts and connections, resulting in corrosion, poor connections and malfunction, particularly if the boat is u Frankie Muniz Racing sed in salt water. Starters with rubber-sealed housing maximize moisture resistance, combating corrosion while increasing starter reliabilit .
|