Frankie Muniz Racingangle away from each other. Screw the horizontal piece to the two longer ones. Lay another horizontal piece near the bottom of the two legs. Screw this piece to the two legs.Turn the construction over. Screw one central 5-foot slat to the horizontal piece to act as the back for t he canvas. Screw another horizontal piece over the central back to act as the rest for the canvas. Turn the construction over again. Attach the hinge to the back of the top horizontal piece. Attach the last 5-foot slat to this hinge, creating the third leg. Considerations Althoug tumblr logo h a basic field easel should be stable and allow the artist to paint on a canvas while standing up outside, the easel can have more features . Stain it to protect against weather and improve its finish. Attach a box or tray to hold paint supplies. Add adjustable-length legs to cha Frankie Muniz Racing nge the height of the easel for standing or sitting.Cotton Candy Toss 1 Fill a clean plastic bag with cotton candy. Tie it closed. You can u . til you have 30 slips of paper. Place the slips of paper in a bucket. 3 Arrange the players in a circle. Have them throw the cotton candy to each other. Each person who catches it removes a question from the bucket and answers it. Pin the Cotton Candy on the Cone 4 Draw a long tr iangle onto a piece of poster board. Cut it out. Tape it to the wall. 5 Cut out eight to 10 circles from the poster board. Brush white glue over the circles. Sprinkle pink glitter onto the circles. Set aside the circles to dry. 6 Lay white stuffing onto a flat surface that can be recommendation letter painted. Spray paint the stuffing with pink spray paint. Leave it to dry. 7 Apply tacky glue to the glittery circles. Press pieces of the p ink-painted stuffing to the circles. The stuffing doesn't need to cover the entire circle. The glitter is visible through the gaps in the st Frankie Muniz Racing uffing. 8 Press a piece of double-sided tape on the back of each circle. The players wear a blindfold and try to put the piece of cotton can . and remove the spool of film. 3 Use the scissors to cut the leading edge at an angle. 4 Load the film onto the reel, pushing the leading edg e into the slot in the center of the reel and winding the rest of the film around. Handle the film by its edges. 5 Place the reel into the d eveloping tank and close the lid. Move back into a lit area. Developing the Film 6 Mix the developer, stop bath and fixer solutions and brin g them up to the recommended temperatures using the tray and a water bath, usually about 68 degrees. 7 Start with the developer. Remove the ebooks free small, inner lid from the developing tank and pour in the developer. Reseal the inner lid and set the timer for the recommended time, which can range from four or five minutes to up to 20 minutes. 8 Agitate the developing tank in 30-second intervals by turning it up and down or u Frankie Muniz Racing sing a twisting motion. Also tap the tank on a hard surface occasionally to remove any air bubbles. 9 Remove the tank's inner lid, dump out .
|