Frankie Muniz Racingthe glass eyeballs you have purchased. 12 Remove the cartilage from inside the ears of the deer cape and replace it with the ear forms that came with the deer head form. If the forms do not fit snug, sand them down with fine-grit sandpaper until they do. 13 Cover the deer form wi th hide paste. 14 Lay the deer cape on the form and pull it taut. Sew an incision using a hidden suture. This is where you stitch the skin t ogether below the surface by weaving the needle from side to side within the lower few layers of tissue. You will create a seamless suture t ebooks online o give the deer mount a professional look. 15 Glue the antlers and glass eyeballs in place. 16 Apply modeling clay to the nose area and shap e it to look like a deer nose. Allow this to dry, then paint it black. 17 Mount the deer on the plaque that came with the deer form and hang Frankie Muniz Racing it upside down on a wall for two weeks. This will allow the cape to dry completely before you display your finished product.1 Turn your met . g for all available metals, you will automatically return to the main menu.1 Review the data sheet for the full-color LED. Determine which l eads are the anodes for the respective colors and which one serves as the common cathode. 2 Select the proper value of resistor for each col or of LED. These resistor values can be determined by the equation: R = (Vs - Vf)/If. The variable "Vs" is the source voltage, which is 5 vo lts for this circuit every time a pulse is delivered to the respective anode. Variable "Vf" is the forward voltage for a specific color of L html website templates ED. The forward current is represented by "If," which is measured in amps. The data sheet supplied with the device will list the nominal val ues for "Vf" and maximum "If." 3 Solder the resistors to the anodes. Take only one lead from each resistor and use the rosin core solder and Frankie Muniz Racing soldering iron to connect it to the appropriate anode. 4 Prepare wires for to connect to the resistors. Using the wire cutter and wire stri . e. The other end is not connected to anything until the next step. 6 Connect the wires to the pulse width modulator. This entails the unconn ected end of each wire from the previous step. You may either have to plug the wire into a connector or clamp it in place with a screw termi nal post. Make sure that you connect the cathode to the circuit ground and each of the other wires to its own dedicated pulse width modulato r output. 7 Test the full-color LED circuit. Turn on the power to the pulse width modulator and vary the pulse widths delivered to the red, marble texture green, and blue anodes. The method for adjusting the pulse width will depend on the pulse width modulator you are using. The pulses could ei ther be varied by adjustment knobs or through software, so you may need to consult any directions you may have supplied with it. The end res Frankie Muniz Racing ult is a rainbow of colors that can emit from the full-color LED.Hazards from Skin Contact Like all wood finishes, you need to avoid contact .
|