Frankie Muniz Racingthe upright position.1 Detach the pieces of the vegetable steamer by pulling the pieces around the main part of the steamer off. 2 Use tin snips to cut the tabs off the top of every other piece you pulled off the vegetable steamer. 3 Place a zip tie through the second hole in th e row on the bottom edge of a metal piece and place a second zip tie in the fifth hole on the bottom row of the metal piece. 4 Use zip ties to tie spacers onto the metal pieces that have tabs at the top of the plate. Once you have added spacers to the metal pieces, it is time to font generator connect them together. 5 Lay the plates with the tabs on top in the opposite direction of the plates without top tabs. This makes a positive and negative plate setup. Connect the metal pieces together using two zip ties through the middle holes in the plates on the last, middle a Frankie Muniz Racing nd top row and zip the ties secure. Use scissors to cut off the excess edges. 6 Insert a hose clamp through the tabs on the tops of the meta . tabs and cut the metal clamp with tin snips so that it is even. 7 Use a rotary tool with a bit corresponding to the bolt size to allow the b olts to fit through on either side of the hose clamp tops in the center of the tabs. 8 Place the metal piece with the hose clamp onto the un derside of the 3-inch cap to mark holes to drill through. Match the holes on the metal hose to the 3-inch lid and mark it for drilling. 9 In sert the two bolts through the metal hose holes and then place a washer over the metal hose. Insert the bolts through the 3-inch cap and use home icon a wrench to tighten the bolts into place. 10 Drill a hole into the top of the 3-inch cap for the hose adapter to fit into. Insert the hose adapter into the hole into the top cap. 11 Place a metal hose around the diameter of the 3-inch cap and place the metal piece into the wide Frankie Muniz Racing mouth jar and tighten the metal hose around the diameter of the 3-inch cap. 12 Fill the wide mouth jar with tap water until there is about 1 . d. 14 Connect a second electrical wire to the right side of the bolt which is the positive side. Attach the positive side to the positive sw itch. 15 Attach a radiator hose to the adaptor on top of the 3-inch cap.1 Inspect the portions of the dock posts that are above water level for minor problems such as loose nails. Put on your goggles, snorkel and flotation device and place your face in the water. Use your hands a nd vision to identify large problems such as loose, rotting wood, excessive marine life growth and displaced posts. 2 Treat any wood that wi letter of recommendation format ll replace posts in the water with deck sealant. Apply at least two coats according to the manufacturer's instructions and allow the sealant to dry. Place the new post beside the existing one in the water. Turn on your water pump and use its hose to displace the sand at the base Frankie Muniz Racing of the replacement post, allowing it to sink into the sand bed. Drive the post at least 4 feet into the bed floor. Use your water pump to mo .
|