Frankie Muniz Racingr and needs to be attached to the exisiting control lines. Use the epoxy to hold it into place. 8 Place the receiver on the underside of the tail, slightly further in than the micro-servo. Connect it to all of the micro-servos using the existing control lines. Cut two half-inch p ieces of Velcro and use them to hold the receiver in place, with one piece of Velcro on either end. 9 Attach the propeller to the front of t he engine. Unscrew the propeller nut and thread the center of the propeller over the base. Screw the nut back in by hand until it is secure. Paleo Diet Be careful not to over tighten the nut, or the propeller will not spin correctly.Scavenger Hunt Stimulate kids' imaginations and help devel op their sense of fantasy by hosting a scavenger hunt throughout the playground. Create homemade maps that show kids a route through the pla Frankie Muniz Racing yground, with a variety of clues sprinkled around the map. This will help kids to view their playground with new eyes and stimulate their de . rica on the ground of the play area. Make each state several yards long. Divide students into several groups and have each group responsible for a state. Each group has to draw distinguishing features about each state, such as national parks within the state boundaries, features of major cities such as the Mall of America in Bloomington, Minnesota, major rivers, lakes and mountain ranges, and cities where instrumenta l Americans were born. The group that does the most thorough and inventive work wins the game. State Capitals This game is appropriate for a milkshape 3d school playground that has a huge map of the U.S. painted on the ground. Assemble a group of kids, with one child being the leader of the g ame. The leader has to shout out the name of a state capital, but not the state that it's in. All the kids, upon hearing that city name, hav Frankie Muniz Racing e to run to that state. Any kids who run to the wrong state are out of the game.1 Cut four pieces of wire about 3 inches long and remove 1/4 . and the short lead is the cathode. 3 Insert the free ends of the four wires into the breadboard so that each wire has its own column on the board. Connect one of the resistor's leads to the wire belonging to the switch's common lug. Put its other lead into an unshared column. Con nect the battery clip's black wire to this column. 4 Connect the cathode lead of the red LED to the wire belonging to the first throw lug of the switch. Connect the LED's anode lead into a free column. Insert the anode leads of the green and yellow LEDs into this same column. Pla cursive font ce the battery clip's red wire at this column. Connect the cathode leads of the green and yellow LEDs to the second and third throw lug wire s, respectively. 5 Connect a 9-volt battery to the clip. One of the LEDs should light up. Flip the switch through its three positions. You s Frankie Muniz Racing hould see the other LEDs light up one at a time.Parachute Playing with a round parachute may be old hat to adults, but it's new fun for many .
|