Frankie Muniz Racingcover and you see two terminal blocks. The terminal blocks have three connections; hot, neutral and ground. One block is labeled "In", or s omething similar and the other block is labeled "Out", or something similar. Loosen all the terminal screws using a screwdriver. You only ne ed to loosen the terminals labeled "Hot" and "Neu", if the wire is dual-core. If the wire is tri-core then loosen all six terminal screws. 3 Strip 1-inch of plastic covering off the two ends of the wire you have just cut using wire strippers. You either reveal two or three intern fantasy models al colored wires, depending on if the electrical equipment is wired to ground. Remove ?-inch of colored plastic off the four or six internal colored wires using wire strippers. This exposes the metal core that connects to the terminals in the SPDT transfer switch. 4 Insert the wh Frankie Muniz Racing ite or gray wire that connects to the power source to the "In" terminal block under the screw labeled "Neu" then tighten the screw. Insert t . of the other wire you cut into the terminal block labeled "Out." The white or gray attached to the "Neu" terminal, the black, red or orange to the "Hot" terminal and, if you have a third wire it connects to the "Gnd" or "T" terminal. Tighten the three screws. 6 Replace the cover on the SPDT transfer switch. Insert the screws and tighten then. Reconnect the wire to the power source.Creating the Mold 1 Determine the si ze of the gas tank you will be creating a mold for using your measuring tape. In most cases the simplest way to attain these measurements is cool font to use an existing compatible gas tank. 2 Purchase blocks of floral arrangement foam from a craft store. This foam is usually dark green, a nd can be bought in a variety of different shapes and sizes. The foam will be used to carve out a mold of your gas tank, so you may need to Frankie Muniz Racing purchase multiple blocks of foam to cover the size of the tank. 3 Use spray adhesive to connect multiple blocks of floral foam together. All . sculpt. 5 Stop sculpting occasionally to ensure symmetry on both sides of the foam. Use your knife to pare down uneven edges, measuring each side with the measuring tape for precision. 6 Use low-grit sand paper (grade 220 to 400) to sand down the foam and finalize your mold desig n. 7 Coat the interior of the mold with a liberal coating of mold-release wax. This wax will ensure that the fiberglass does not stick to th e mold as it cures. Pouring and Curing the Fiberglass Tank 8 Cut your fiberglass cloth to the necessary shape and dimensions using scissors. free icons download 9 Mix your epoxy resin in a small container, stir the resin thoroughly to attain an even consistency. 10 Coat the interior of the mold with resin, use a paint brush to ensure that it is evenly distributed. 11 Apply the fiberglass cloth over the resin. Apply pressure to the cloth Frankie Muniz Racing as you lay it to avoid folds or wrinkles in the cloth. 12 Coat the exterior layer of fiberglass cloth with resin, then lay a second layer o .
|